DT01511 Projector Lamp for HITACHI CP-AW2505EF

Replacement Projector Lamp for the Hitachi CP-AW2505EF

This lamp also fits

Hitachi CP-CX301WN, Hitachi CP-BX301WN, Hitachi CP-AW2505, Hitachi CP-CW250WN, Hitachi CP-CW300WN, Hitachi CP-CX250, Hitachi CP-CX300WN, Hitachi CP-AX2504, Hitachi CP-CX251N, Hitachi CP-AX2503

About this lamp

This is a compatible replacement lamp module for the Hitachi CP-AW2505EF, replacing Hitachi part DT01511. The same lamp is also sold under part numbers DT01431, DT01433, DT01435, DT01481, DT01571, DT02051, 456-8527, 456-8928A, 456-8931WA, 456-8934, so it fits a wide range of Hitachi, Dukane and Maxell projectors. It's a complete unit – the bulb is already fitted in a new housing – so there's no handling the bare bulb and no rewiring. Every lamp is tested before it leaves our US warehouse.

Compatible or Original Inside?

This is our compatible version: a quality third-party bulb in a new housing, built to match the original brightness and lamp-life specification at a much lower price, with a 120-day warranty. If you'd rather have a genuine original bulb, we also sell an Original Inside version for the Hitachi CP-AW2505EF – a genuine original bulb in a new housing – which comes with a 180-day warranty.

When to replace the lamp

Most projectors warn you when the lamp is near the end of its life: a lamp replacement message appears when you switch on, and the lamp indicator may light or flash. Before that, most people notice the picture getting dimmer or colors looking washed out. If the projector won't light at all, the lamp has usually failed.

How to fit it

Switch the projector off, unplug it and let it cool for at least 45 minutes. Remove the lamp cover, loosen the screws holding the old lamp and lift it out by the handle. Push the new lamp firmly into place, tighten the screws and refit the cover securely – most projectors won't power on if the lamp cover isn't closed properly. Finally, reset the lamp timer from the projector's menu so it stops showing the replacement warning (your user manual shows the exact steps for your model).

Questions

How do I know this is the right lamp? Check the model name on your projector, or the part number on the old lamp – if it shows DT01511, or any of the part numbers listed above, this lamp fits. If you're still not sure, contact our sales team and we'll confirm the right lamp for you.

Can schools and colleges order on a purchase order? Yes – government and education purchase orders are welcome. Email or call us and we'll set it up.

What if there's a problem? This compatible lamp has a 120-day no-quibble warranty: if there's a problem in that time, we'll replace it.